
- 33 –
WebEye SPD User’s Guide
9) Serial Port Configuration
WebEye SPD has an RS232C interface
ports for Audio device.
WebEye SPD also support the
specialized Audio Device for WebEye
series called “Voice Messenger”. This is
connected to Audio Device port
physically and enabled at this menu.
To configure this Voice Messenger, select the “Audio Device” at “Select Attached Device”
• AGC Control Enable
: When this
function is enabled, WebEye SPD
will automatically control the input
audio volume up and down
considering the given noise condition.
• Microphone Volume Level : 10 level
control for microphone volume is available.
10) Digital I/O Configuration
User configures digital input states and control script. WebEye SPD sends e-mails or/and files when
connected external sensors detect events.
Active State for Input Port 1 and Port 2:
Administrator defines active state of 2
digital devices connected to two input
ports such as infrared sensors. Active
states of digital devices may differ
depending on items or models (select
between ‘NO’ or ‘NC’).
Current State for Input Port 1 and Port 2: WebEye SPD shows current states of the two digital
devices connected to two input ports. In the status panel, active state or de-active state message
shows. ‘De-Active State’ means that connected sensor didn’t detect any event when ‘Apply button’
is clicked. Though this message is not updated until you click ‘Apply’ button again, WebEye SPD
receives signal from sensor.
Comentarios a estos manuales