WebGate WebEye A10 Guía de usuario descargar pdf (Pagina 14)

- 14 –

WebEye SPD User’s Guide

2) Assigning IP Address to WebEye

After keying in the administrator’s password, click ‘Change

IP Addr’ button to change your WebEye’s IP address. Type

in a new IP address that you are going to assign to your

WebEye. Then confirm it with the ‘OK’ button.

3) Configuring Administrator’s Conditions

After assigning a new IP address to user’s WebEye (select a WebEye), you

may configure the administrator’s condition of the WebEye. When you click

‘Start Configuration’ button, the Setup program automatically connects you

to Admin page of WebEye Homepage. (For more detailed information, refer to Chapter VI

‘Configuring Administrator’s Condition at Homepage’)

3. Assigning IP Address with ARP Command

1) Using ARP in Windows 98 and NT

When the PC’s operating system is Windows 98 and Windows NT, follow as below.

•

Open a DOS window and type the following commands.

Arp -s <WebEye IP address> <WebEye Ethernet address>

Ping -t <WebEye IP address>

• Example

Arp -s 192.168.1.3 00-40-8c-10-00-86

Ping -t 192.168.1.3

2) Using ARP in Windows 95

When the PC’s operating system is Windows 95, follow as below.

• Open a DOS window and type the following commands.

Arp -s <WebEye IP add.> <WebEye Ethernet add.> <my PC IP add.>

Ping <WebEye IP address>

• Example

Arp -s 192.168.1.3 00-40-8c-10-00-86 192.168.1.2

Ping 192.168.1.3

3) Verifying Installation

After completing task successfully with above procedures, a following message or similar ones will

appear on the screen:

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 50 51

Sin comentarios

WebGate WebEye A10 Guía de usuario Pagina 14