WebGate WebEye A10 Guía de usuario descargar pdf (Pagina 13)

- 13 –

WebEye SPD User’s Guide

2. Assigning IP address and configuring administrator’s condition with setup program

1) Starting a Setup Program of WebEye

Click the file ‘WebEyeSetup.exe’ on

your PC. When the setup program is

executed, the setup program detects and

shows every WebEye connected at the

local network.

Among the WebEyes, choose one that

you want to assign a new IP address.

(Default figure is 211.53.133.92). To

choose a WebEye is to click on its MAC

address or IP address.

When a WebEye is selected, an IP

address shows in the blank of ‘Selected

IP Address’. You should key in a

password in the blank of ‘Admin’s

Password’ to assign (or change) IP

address to WebEye and to set up it.

Default password is ‘admin’.

After then, you can change IP address by

clicking ‘Change IP Addr’ button or set

up by clicking ‘Start Configuration’

button.

If WebEye has any problem, you can

reboot without adjusting power supply. ‘Reboot’ button works as on/off switch.

IP Address Assigning Methods

• With setup program

- Assemble and place WebEye

- Assign IP address to WebEye using setup program on local network.

- Access WebEye through Web browser with the IP address and configure user’s

condition and administrator’s condition.

- If it is impossible to assign IP address with setup program, try it with ARP command

•

With ARP command

- Assemble and place WebEye

- Assign IP address using ARP command on local network

- Access WebEye through Web browser with the IP address and configure user’s

condition and administrator’s condition.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 50 51

Sin comentarios

WebGate WebEye A10 Guía de usuario Pagina 13