WebGate WebEye E10 Manual de usuario descargar pdf (Pagina 5)

3. Install WebEye Setup program in your PC

l Copy WebEyeSetup.exe file from the enclosed CD (or Diskette).

l Paste the file into your PC

l Click the file on your PC to activate Setup program.

4. Assign IP address to WebEye with Setup program.

l Activate Setup program and assign a new IP address to WebEye.

l Change IP address from default one to a new one available on your local

network. Connected on a same local network, any IP address of WebEye

appears on Setup window even if the IP address is from remote network range.

l A user on the local network may access WebEye, when WebEye is assigned a

proper IP address of the local network, though if gateway address, broadcast

address and network mask are not assigned properly. However remote user

cannot access the WebEye without assigning its gateway address, broadcast

address and network mask properly.

l Even when you connected directly WebEye to a PC, you cannot access

WebEye if you don’t assign WebEye with local IP address

. Select the default IP address of

WebEye (211.53.133.92).

2. & 6. The selected IP address

appears (211.53.133.92).

3. Enter Admin’s

password. Default

password is ‘admin’.

. Click ‘Start Configuration’ button, to

access WebEye through Internet and

configure administration conditions.

5. After changing IP address, the

new IP address appears. C

lick on

the IP address.

4. Click this button to change IP

address. Upo

n clicking the button,

a new window appears where you

change IP address.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Sin comentarios

WebGate WebEye E10 Manual de usuario Pagina 5